CONMOLY | CM-GLINK-SQ | GLink Bus Cables
Shenzhen Xinju New Materials Technology Co., Ltd.
https://conmoly.com

Catalogue values support selection. Final tolerances, assembly performance and acceptance tests are defined in the approved drawing and specification. No certification is implied.
100-ohm, 24 AWG data-bus cable with low-density PTFE insulation and two shielding layers, for equipment networks and compact signal routing.

Typical attenuation at +25 °C and sea level. Connector, link length and protocol compatibility are confirmed for the complete channel. The filler material and minimum installation bend radius are defined in the approved drawing.
Impedance: 100 Ω | Nominal
Capacitance: 44 pF/m | Listed model
Intra-pair skew: 15 ps/m | Listed model
Operating temperature: −65 to +200 °C | Finished cable, not dielectric material rating
Near-end crosstalk: ≥25 dB | 2500 MHz
Dielectric withstand: 1500 / 1000 V AC | Conductor–conductor / conductor–shield; duration to be agreed

GLink construction
Code | Conductor (AWG / stranding) | Core diameter (mm) | Shield diameter (mm) | Overall diameter (mm) | Mass (g/m)
CM-GLINK-SQ-AWG24 | 24 (19/35) | 1.15 | 3.4 | 3.8 | 32

GLink construction · typical attenuation (dB/m)
Frequency (MHz) | CM-GLINK-SQ-AWG24
312.5 | 0.4
500 | 0.52
625 | 0.58
750 | 0.64
1000 | 0.75
1250 | 0.86
2500 | 1.3

Typical attenuation at +25 °C and sea level. Connector, link length and protocol compatibility are confirmed for the complete channel.
The filler material and minimum installation bend radius are defined in the approved drawing.
GLink construction: CM-GLINK-SQ-AWG24
Conductors: Silver-plated copper strands.
Insulation: ePTFE / PTFE; low-density PTFE separating tape.
Shield: Silver-plated copper tape and braided conductor layers.
Jacket: Fluoroplastic.
Signal and frequency: Protocol, frequency band, impedance and loss budget.
Installation: Length, routing, bend radius, motion and available space.
Environment: Operating temperature and required environmental tests.
Termination: Connector, pinout, shielding and strain relief.

Impedance and attenuation at agreed frequency points
Continuity, insulation resistance and dielectric withstand as specified
Application-specific bend, temperature and assembly verification
Equipment data networks
Avionics and imaging interconnects
Compact industrial signal routing
Cable supply or project-specific termination
Confirm connector and cable compatibility before assembly
Catalogue values support selection. Final tolerances, assembly performance and acceptance tests are defined in the approved drawing and specification. No certification is implied.
Cable Product Manual · A1 · PDF pages 29, 30
Source: https://conmoly.com/resources