Conmoly | CM-RF-AIRFRAME | Ruggedized Airframe Microwave Assemblies
Shenzhen Xinju New Materials Technology Co., Ltd.
https://conmoly.com

Selection reference; third-party published figures are not Conmoly guaranteed specifications or certifications. Final specifications require configuration review. Images illustrate product form.
Reference configuration: Lightweight flexible 50-ohm RF assemblies for civil and military aircraft, maintaining link performance through 40 GHz across routing, maintenance, vibration and flight conditions.

Types 04, 65, 6E and 6G differ in frequency, loss, diameter and bend radius.
Maximum frequency: 18–40 GHz | By cable type
Typical VSWR: 1.25:1–1.30:1 | At maximum frequency, straight connector
Guaranteed VSWR: 1.40:1–1.45:1 | At maximum frequency, straight connector
Typical insertion loss: 0.198–0.795 dB/ft | At each type's maximum frequency
Standard impedance / shielding: 50 ± 1 Ω · > 90 dB | Shielding through 18 GHz
Diameter / minimum bend radius: 4.55–8.9 / 12.5–48.3 mm | By cable type
Temperature / concentrated load: −55 to +125 °C · > 150 lb | MIL-T-81490 load condition
Source: https://www.gore.com/products/ruggedized-airframe-microwave-rf-assemblies

Types 04 / 65 / 6E: 18 GHz families selected by loss, diameter and bend radius.
Type 6G: Compact 40 GHz airborne assembly.
Replaceable-connector assembly: Ends configured to equipment interface and maintenance strategy.
Silver-plated center conductor: Solid or stranded geometry is selected for frequency, power, flex and termination.
Expanded PTFE dielectric: Maintains 50-ohm coaxial geometry while reducing high-frequency dielectric loss.
Multilayer outer conductor: A stable return and shielding path limits impedance change after installation.
Rugged or barrier jacket: Resists crush, abrasion, bending, vapor and aircraft-fluid ingress.
Replaceable connector: Interface, direction, length and service strategy complete the assembly.
Frequency and power: Maximum frequency, CW/pulse power and link loss
Amplitude and phase: VSWR, insertion loss, phase, delay and thermal stability
Assembly length: Equipment spacing, service loop, route and matching
Installation: Diameter, mass, bend radius, crush and maintenance loads
Environment: Temperature, vibration, vapor, fuel, fluids and EMI
Connector: SMA, TNC, 2.92 mm and replaceable-interface options

Full-band insertion loss, return loss, VSWR and amplitude/phase
Comparison before and after installation bending, crush and connector fit
Thermal cycle, vibration, fluid or vapor-barrier tests
Repeated mating, tensile and torque retention
Airborne radar and electronic warfare
C5ISR and signal intelligence
Navigation, communications and SATCOM
Airborne millimeter-wave equipment
SMA, TNC, 2.92 mm and related RF interfaces
Straight, right-angle and low-profile connectors
Fixed-length assembly and replaceable connector interface
RF values vary by cable type, frequency, length and connector. The finished assembly must be tested in its defined configuration.