Conmoly | CM-RF-SEALED | Vapor-Sealed Microwave RF Assemblies
Shenzhen Xinju New Materials Technology Co., Ltd.
https://conmoly.com

Selection reference; third-party published figures are not Conmoly guaranteed specifications or certifications. Final specifications require configuration review. Images illustrate product form.
Reference configuration: A durable barrier prevents water, vapor, fuel and aircraft contaminants from entering while maintaining low loss, phase stability and high shielding through 40 GHz.

Types 7G, 75, 7E, 7L and 7M cover different frequencies, diameters and bend radii.
Maximum frequency: 2–40 GHz | By cable type
Typical VSWR: 1.10:1–1.30:1 | At maximum frequency, straight connector
Typical insertion loss: 0.04–0.78 dB/ft | At each type's maximum frequency
Standard impedance / velocity: 50 ± 1 Ω · 85% | Full family
Shielding effectiveness: > 90 dB | Through each type's maximum frequency
Diameter / minimum bend radius: 3.80–14.35 / 19–80 mm | By cable type
Temperature / concentrated load: −58 to +200 °C · 50 lb/in | Full family
Source: https://www.gore.com/products/vapor-sealed-microwave-rf-assemblies

Types 7G / 75 / 7E: Compact low-loss families spanning 18–40 GHz.
Types 7L / 7M: 2–7 GHz and larger power/diameter direction.
Replaceable-connector assembly: Defined around SMA, TNC and related interfaces and length.
Silver-plated center conductor: Solid or stranded geometry is selected for frequency, power, flex and termination.
Expanded PTFE dielectric: Maintains 50-ohm coaxial geometry while reducing high-frequency dielectric loss.
Multilayer outer conductor: A stable return and shielding path limits impedance change after installation.
Rugged or barrier jacket: Resists crush, abrasion, bending, vapor and aircraft-fluid ingress.
Replaceable connector: Interface, direction, length and service strategy complete the assembly.
Frequency and power: Maximum frequency, CW/pulse power and link loss
Amplitude and phase: VSWR, insertion loss, phase, delay and thermal stability
Assembly length: Equipment spacing, service loop, route and matching
Installation: Diameter, mass, bend radius, crush and maintenance loads
Environment: Temperature, vibration, vapor, fuel, fluids and EMI
Connector: SMA, TNC, 2.92 mm and replaceable-interface options

Full-band insertion loss, return loss, VSWR and amplitude/phase
Comparison before and after installation bending, crush and connector fit
Thermal cycle, vibration, fluid or vapor-barrier tests
Repeated mating, tensile and torque retention
AESA radar
Electronic defense and signal detection
SATCOM and GPS
L-band air-to-ground communications
SMA, TNC, 2.92 mm and related RF interfaces
Straight, right-angle and low-profile connectors
Fixed-length assembly and replaceable connector interface
RF values vary by cable type, frequency, length and connector. The finished assembly must be tested in its defined configuration.