conmoly 鑫聚新材
中文Contact us

CONMOLY

VNA RF Test Cables: What to Specify Before Selection

Published / updated:

A VNA test cable sits between the instrument setup and the device being measured. Its required length, interfaces and handling conditions depend on that setup. Before selecting a construction, describe where calibration will be performed, how the cable will be routed and what will move after calibration.

Start with the measurement reference planes

A reference plane identifies the boundary at which the device under test is connected. Rohde & Schwarz’s VNA calibration guidance explains how measurement calibration corrects systematic setup errors. Record the actual calibration method and reference planes rather than assuming that a cable’s product name defines the measurement boundary.

Identify the required operating band and both mating interfaces. Include adapters and fixtures in the setup description. Decide which items are included in the calibrated path and which are part of the measured device. This keeps an assembly acceptance result separate from a later DUT measurement.

Describe how the test lead will be handled

  • Give the port-to-fixture route and the controlled length datum.
  • Show the bend locations, moving section and connector orientation.
  • State whether repositioning is occasional or follows a defined repeated sequence.
  • Describe strain relief, bench contact and any protection requirement.
  • Define the electrical change that is acceptable during the proposed handling sequence.

A static bend value does not establish repeated-flex life. Similarly, protective construction does not establish crush resistance or an operating frequency rating without the relevant configuration and evidence. Use the bending versus temperature validation guide when those behaviours matter to the measurement.

Screen armoured configurations using their actual dimensions

The following published rows describe CONMOLY’s ruggedized test assemblies. Base cable diameter, armoured diameter and mass are separate selection inputs. They support an envelope review; a project still needs the selected connectors, finished length and acceptance limits.

ConfigurationBase cable diameter (mm)Armoured diameter (mm)Mass (g/m)
CM-COAX-ASM-RG-OD6P503.606.50 ± 0.2088.5
CM-COAX-ASM-RG-OD8P705.508.70 ± 0.20152.0

The VNA test assembly page provides a project-review entry point rather than a fixed table of finished performance ratings. Where a different routing feel is needed, the ultra-flexible cable series can be considered as a cable construction candidate. Neither entry substitutes for the specified assembly evaluation.

Define a repeatable acceptance record

Identify the sample, connectors, length, calibration, frequencies and initial route. Specify insertion loss, reflection and any movement-related phase or amplitude criteria separately. Retain the before, during and after conditions needed to interpret the result. Requested report format and test provision should be agreed for the project.

FAQ: Is an armoured test lead automatically phase stable?

The armour describes a construction feature. Phase behaviour requires its own defined movement or temperature evaluation.

FAQ: Can I choose by connector type alone?

Also review the actual connector parts, required band, cable construction, length, route and test conditions. Interface names alone do not rate the complete assembly.

FAQ: What should accompany a VNA cable enquiry?

Send a setup sketch and acceptance requirements using the custom RF assembly checklist and contact page. Include any fixtures or adapters that affect the measurement boundary.