conmoly 鑫聚新材
中文Contact us

CONMOLY

Data Bus Cable Selection: Cat6A, 1394b, GLink and LVDS

Published / updated:

Choose a data cable family from the equipment interface and system requirement before comparing conductor size. Cat6A, IEEE 1394b, GLink and LVDS entries serve different selection contexts. Similar impedance or insulation material does not make their conductors, shielding, pinout or complete links interchangeable.

Start with the system interface

FamilyPublished nominal impedanceFirst selection question
Cat6A Ethernet100 ΩWhich Ethernet equipment, pair arrangement and termination are required?
IEEE 1394b110 ΩWhich interface, cable construction and system acceptance are specified?
GLink100 ΩDoes the equipment require the listed GLink star-quad construction?
LVDS100 ΩWhich pair geometry, shield and drain arrangement fit the interface?

This map directs the review; it does not certify a link or authorise substitution. Obtain the equipment specification, signal conditions, connector definition and installed length. If a drawing already controls the cable, record its revision and the attributes that may change.

Compare within the relevant published family

The Ethernet page separates base constructions from S02 variants. Compare their own dimensions, mass and temperature entries rather than transferring a property from one suffix to another. The Cat6A AWG guide explains that process.

The IEEE 1394b page contains dimensioned AWG22, AWG24 and AWG26 entries, plus additional attenuation-only entries. A row containing electrical data alone should not be used to invent missing mechanical or environmental limits. See the 1394b application review guide.

The current GLink page lists CM-GLINK-SQ-AWG24, a star-quad construction with nominal 100 Ω impedance, 3.8 mm outside diameter and 32 g/m mass. Match that construction to the equipment and termination requirement; those values do not establish an interchangeable Ethernet or LVDS link.

The LVDS page distinguishes twisted-pair and parallel-pair constructions, with separate drain-wire variants. Begin with the connector layout and termination plan, then use the twisted versus parallel selection guide to compare the available geometry.

Prepare a common review sheet

  • Equipment interface, signal mode and the applicable system document.
  • Cable code, construction, connector pinout and shield or drain termination.
  • Installed length, route, bend conditions and any movement.
  • Model-specific temperature exposure and other environmental requirements.
  • Electrical acceptance conditions, reference setup and the evidence required for the sample.

The harsh-environment signal cable guide expands the signal and environmental inputs. Keep a complete-link performance requirement separate from a cable material description.

FAQ: Can matching impedance justify a replacement?

No. Review the actual interface, geometry, termination, length and system acceptance criteria before proposing a replacement.

FAQ: Does a family name establish link length or data rate?

A family label does not establish the result for the proposed installed link. Specify the system conditions and obtain the applicable evaluation.

FAQ: Where should unresolved interface questions go?

Keep them identified on the review sheet and provide the available drawings through the contact page. Resolve them before treating candidates as comparable alternatives.